Duck Hunting Forum banner

Norinco 7.62x39 SKS Rebuild

2K views 8 replies 4 participants last post by  mox 
#1 · (Edited by Moderator)
I also posted this in the rifle/handgun forum, but theres not much traffic there.

This gun was bought for me as a youngster. Since then its been sold (times were hard and dad needed money) and bought back. Now, 15 yrs later I'm looking to rebuild it with a composite stock and then some...
Where to start? I know I need:
-a magazine
-new stock front to back
-scope
-rail?
Looking for a place for parts around hopkinsville/Clarksville/ft Campbell. Would prefer them to have a good gunsmith.
And may I mention I'm in learning mode as I know nothing about this gun.
It's above the 03-A3. Help!
ImageUploadedByTapatalk1358598588.479829.jpg
 

Attachments

See less See more
1
#7 ·
FOWLER2671 said:
mox said:
FOWLER2671 said:
You wanna sell the 03-a3?
Not at the moment. Haven't had it appraised in a while. I'll probably post it here if I ever decide to sell though.
I have an M1 and an appreciation for the guns of freedom. That would be an interesting addition.
I understand. Mine isn't in mint condition, but its a '43 model so I guess you'll get a couple scratches over 70 yrs.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top