m3500

A shotgun forum for basic gun smithing, repair, modifications, and all other detailed shotgun information.

Moderators: waterfowlhunter, don taylor

m3500

Postby blownsled » Tue Sep 04, 2012 3:09 pm

brand new m3500 double feeds sometimes resulting in a jammed gun any ideas out there?
blownsled
hunter
 
Posts: 37
Joined: Tue Feb 07, 2012 4:52 pm


Re: m3500

Postby T Man » Wed Sep 05, 2012 5:02 am

Pull the trigger assembly and put it in boiling water for about a minute. Remove, scrub with dish soap and an old toothbrush, rinse, then return to the boiling water for another minute. Assby should be fairly dry almost as soon as it comes out of the water but blow out with air or place on a fan until dry. Give it a good coat of CLP once it is dry. While trigger assembly is out of the gun, spray down inside of receiver with CLP powderblast and scrub, focusing on the release button assembly. If the gun is brand new, there may be packing grease still in there causing it to stick open. If not, there may be a damaged spring causing the problem.
Botiz630 wrote:How much does an apostrophe cost down south? Must be quite a bit, based on how sparingly you use them.
User avatar
T Man
Super Moderator
 
Posts: 5514
Joined: Thu May 06, 2010 7:42 pm
Location: Everywhere the English language is being abused...


Return to Shotgun Repair & Modifications Forum

Who is online

Users browsing this forum: No registered users and 8 guests