Shims for Browning Silver

A shotgun forum for basic gun smithing, repair, modifications, and all other detailed shotgun information.

Moderators: waterfowlhunter, don taylor

Shims for Browning Silver

Postby tbarto » Tue Apr 02, 2013 12:58 pm

I posted this in the other forum but it might not be the right place. Has anyone ever installed shims from the Browning Gold FLD into teh Silver? IS there any modifications required to get them to fit. I jusat ordered a few and plan to see how they fit. My silver is shooting slightly left with most all loads. Thanks!
tbarto
hunter
 
Posts: 90
Joined: Fri Dec 03, 2010 8:07 am


Re: Shims for Browning Silver

Postby Yuchi1 » Mon Apr 08, 2013 11:50 am

Never tried them when I had those shotguns....however, you might check and make sure the choke tube well is bored (from the factory) concentric to the bore.

Remove barrel and hold up to a light source while looking up the bore and note the area where your choke tube seats into the rear of the well. There should be a slight dark ring at the base of the choke tube where it butts up to the bore. If, it looks more of a crescent moon image, your choke tube is likely sitting eccentric to the bore which will make it shoot off from POA. Basically, it that's the case, the only good fix is a new barrel.
Sent from my Sumerian tablets

Does the number of bands claimed simply mean you have an Ebay account?

FSH Pro Staffer

High Potentate, NSSB (no spinning shotcup brotherhood)
Yuchi1
hunter
 
Posts: 1626
Joined: Wed Jan 17, 2007 9:15 pm
Location: Creek Nation of Oklahoma

Re: Shims for Browning Silver

Postby clampdaddy » Mon Apr 08, 2013 10:21 pm

I believe that the shims for the Gold Evolve fit the Silver.
User avatar
clampdaddy
hunter
 
Posts: 3635
Joined: Tue May 24, 2011 9:23 pm
Location: Where spoonies go to die


Return to Shotgun Repair & Modifications Forum

Who is online

Users browsing this forum: No registered users and 5 guests