flyndutchman wrote:Set it up with the shims as described in the manual or you run the risk of bending the action spring tube and it won't cycle. There should be a plate supplied in the shim kit that allows you to have neutral cast.
flyndutchman wrote:You are correct, no neutral cast plate. My bad. Try contacting Benelli, you would think that option should be available. I can think of a way to do it with a dremel tool and leaving out the cast shim but you woud have to be careful with assembly and making sure the plate stayed in place.
lostknife4 wrote:If you put both the right and left shims in you will get neutral.....
waterfowlhunter wrote:lostknife4 wrote:If you put both the right and left shims in you will get neutral.....
The left is the right just turned over. you would have to get another shim to do that
clampdaddy wrote:My sbe2 has more cast than I'd like. I was thinking of making a new plate (the one that goes inside the stock) with a hole drilled in the center. Could I just leave out the thin cast shim and run the drop shim only? Any thoughts?
Users browsing this forum: No registered users and 13 guests