Guys, I could really use some help. Duck season starts Saturday.
I took my X2 apart this weekend to give it a good cleaning and oiling before the opening weekend. I just broke it down into the major components, nothing over zealous. As I was blowing the crud out of the trigger assembly, I noticed an extra cotter pin laying in the trigger assembly. And I hadn't taken any of this apart. I looked all over the trigger assembly and I can't find a hole that receives this pin.
I found this exploded view: http://www.gunpartscorp.com/Manufacturers/Winchester-33573/Shotguns-42603/SuperX2-41831.htm
. In the exploded view, there are two of these small hairpin cotter pins in the gun; items #19 and #22. On my gun, #22 is in place. I had never noticed #19, and I can't see anywhere that this pin would go.
Any suggestions would be greatly appreciated.