Need Instructions

A shotgun forum for basic gun smithing, repair, modifications, and all other detailed shotgun information.

Moderator: waterfowlhunter

Need Instructions

Postby trouttracker » Tue Dec 23, 2008 8:23 am

Can anyone tell how are where I can get a drawing how to remove the trigger assem. from a BPS.

Posts: 108
Joined: Tue Jul 17, 2007 6:38 am
Location: Lake Jackson

Remove Advertisements

Postby Willow Lake » Tue Dec 23, 2008 10:37 am

Browning should have the info in the manual. Just punch the two pins on side of receiver out and pull down, the trigger assembly should come out. Be careful though, the rail in the side of the receiver that provides the shell stop will come out and it can be very difficult to put back in the first time you try it.
Second place is dead last in a one dog race!
Willow Lake
Posts: 21
Joined: Mon Dec 22, 2008 6:00 am
Location: MS

Postby don taylor » Tue Dec 23, 2008 11:40 pm

I've never looked but I'd bet there is a exploded diagram on Numrich. Be careful.

Chairman- The Allegheny Chapter of Delta Waterfowl. ... 6859634909
User avatar
don taylor
Forum & State Moderator
Posts: 7534
Joined: Fri Feb 01, 2008 7:38 pm
Location: Westmoreland County, Pa.

Postby bgoldhunter » Wed Dec 24, 2008 12:19 am

Push two pins out. Slide rear of trigger housing up and out. Rest of housing will follow. If you've never torn one down, you may want to try and hold the shell stops in place with one hand as you pull the housing out (but you may not have much luck). Look at proper placement of stops and let go...they will most likely fall into the receiver. Note where the hammer pin is located.

Clean and reassemble.
User avatar
Posts: 2566
Joined: Wed Jul 21, 2004 9:46 pm
Location: Missouri

Return to Shotgun Repair & Modifications Forum

Who is online

Users browsing this forum: No registered users and 3 guests