How to put sling on Beretta 390/3901?

Share your questions on all makes and models of shotguns. Please post chokes questions in the SRBC forum

Moderators: Quack Wacker NC, MM

How to put sling on Beretta 390/3901?

Postby glen1978 » Mon Nov 11, 2013 11:37 am

Ive got 3 of these guns and need slings on at least two of them. Whats the best way to do it and where do I get the parts? Ive read on here and what worked for some seem to not work at all for the next guy/gun.
glen1978
hunter
 
Posts: 78
Joined: Wed Jun 13, 2012 2:13 pm
Location: Palestine, Texas


Re: How to put sling on Beretta 390/3901?

Postby jph4387 » Mon Nov 11, 2013 2:03 pm

viewtopic.php?f=100&t=172041

Here is a thread from when I was going through the same thing.
"Whack 'em, stack 'em and pack 'em."

-Ted Nugent
User avatar
jph4387
hunter
 
Posts: 138
Joined: Wed Nov 28, 2007 10:58 am
Location: Charlotte, NC

Re: How to put sling on Beretta 390/3901?

Postby tbarto » Wed Nov 13, 2013 11:41 am

I bought a metal ring that went under the mag screw cap. I looked on line and maybe Midway USA ? The ring has a slot for the sling to attach to. I then bought a Mikes adaptor for the stock.
tbarto
hunter
 
Posts: 89
Joined: Fri Dec 03, 2010 8:07 am

Re: How to put sling on Beretta 390/3901?

Postby orphanedcowboy » Wed Nov 13, 2013 11:49 am

tbarto wrote:I bought a metal ring that went under the mag screw cap. I looked on line and maybe Midway USA ? The ring has a slot for the sling to attach to. I then bought a Mikes adaptor for the stock.


I did the same thing, then sent it off and had a para-cord sling made using it, best $45 I ever spent.
NRA Life Member
User avatar
orphanedcowboy
hunter
 
Posts: 1726
Joined: Sun Feb 27, 2005 10:39 am
Location: Ft. Worth, Texas

Re: How to put sling on Beretta 390/3901?

Postby copterdoc » Fri Nov 15, 2013 7:09 pm

Get one of these. http://www.midwestgunworks.com/page/mgwi/prod/C53745

Don't install a sling stud in the hole in the forearm.
That hole is there to vent gas from the piston/cylinder.

If you shine a light and look in it, you'll see that it is aligned with the exhaust port in the cylinder.
You can even work the bolt and watch the piston slide in and out.

Putting a sling stud in that hole is idiotic.
User avatar
copterdoc
hunter
 
Posts: 5843
Joined: Sat Dec 06, 2008 12:55 pm


Return to Shotgun Forum

Who is online

Users browsing this forum: No registered users and 9 guests