Interact with others on shot gun shells, reloading, ballistics, chokes, or anything that has to do with your shooting.
Moderators: donell67, pennsyltucky, NV Guide
I ordered a case of Federal Speed Shok 3.5" 1 1/2 #2s and got them in and the first box I opened almost all of them seemed like they did not get seated all the way and the end of them was ballooned out about a quarter inch or more rather than being recessed like all the kents and winchesters ive typically shot. Started looking through the case and atleast half of the shells were this way. If they were 3" shells I wouldnt be too worried but am concerned these might hang up when they are feeding since there 3.5s. Would this concern any of you or have you noticed this before?
- Posts: 52
- Joined: Sat Feb 12, 2011 3:41 pm
Never noticed it before. Give federal a call and ask what they think you should do.
- Posts: 4350
- Joined: Mon Oct 24, 2011 11:15 pm
BBK wrote:Never noticed it before. Give federal a call and ask what they think you should do.
this good advice they should be sending ya some new shells to replace them they had the machines/componenets off that day that those were made...give them call right away and tell them what you found in the case of there factory ammo.
- Posts: 1268
- Joined: Thu Jul 19, 2012 8:13 pm
Then after they send you a new case of shells you can get a GEAP head from Solway and form the expanded ones better than the factory did or could................
"It's not the game but the chase ~ not the trophy but the race !" from my Dad, many years ago.
- Posts: 5374
- Joined: Sat Apr 03, 2010 4:32 pm
- Location: New Brunswick, Eastern Canada
I once got a couple boxes of fed 3" like that . Not only were the crimps bulged out but you could see the imprint of the pellets in the hull. I shot them without any problems but probably wouldn't try it again.
- Posts: 3284
- Joined: Wed Mar 30, 2011 3:00 pm
Return to Shotshell, Reloading, Ballistics, & Chokes
Who is online
Users browsing this forum: No registered users and 14 guests