AK Ray wrote:Hey, can I get a piece of 1/4" Al plate from you? It will be small but have funny dimensions.
I have been trying to find a piece at the AK Steel scrap yard, but they just don't seem to be messing up too many orders or making enough scrap
If I can get a piece, I'll figure out the height and width one night this week.
Should have the e-mail . It sent ok from my end to the e-mail address you have on the Forum. Check again. If not there I'll re-send it. Give me your address.
A very fine neighbor up here just offered me the use of her mig machine. Very Cool! I'll be able to weld it up myself. Thanks for your offer of help in this project though!
Users browsing this forum: No registered users and 1 guest