Wiring! Rear distribution panel done!

A duck boat forum to discuss duck hunting boats, mud motors, and everything related.

Moderators: Dogman, NCSUDucker

Wiring! Rear distribution panel done!

Postby T Man » Thu Sep 19, 2013 7:55 pm

I tore my decks off, and gutted my wiring in my boat and have been fixing little things here and there, and painting the bilge area. Finally today I am seeing a little bit of forward progress. I ran out of ring connectors, but I got the rear/main distribution panel is DONE. I have 1 more smaller one to make under the console, and a switch panel to make, and then the wiring can be re-run and get the boat floated again!
Botiz630 wrote:How much does an apostrophe cost down south? Must be quite a bit, based on how sparingly you use them.
User avatar
T Man
Super Moderator
Posts: 6102
Joined: Thu May 06, 2010 7:42 pm
Location: Everywhere the English language is being abused...

Remove Advertisements


Re: Wiring! Rear distribution panel done!

Postby TaylorMann1 » Fri Sep 20, 2013 4:56 am

Can't go wrong with heat shrink connectors, nice looking work too!
Posts: 284
Joined: Wed Dec 28, 2011 1:24 pm
Location: Mechanicsville,VA

Re: Wiring! Rear distribution panel done!

Postby threedogs » Fri Sep 20, 2013 5:27 am

Very nice!
Thread Killer
Posts: 1132
Joined: Thu Oct 25, 2012 10:52 pm

Return to Waterfowl Boats, Motors, & Boat Blinds

Who is online

Users browsing this forum: No registered users and 5 guests