A duck boat forum to discuss duck hunting boats, mud motors, and everything related.
Moderators: Dogman, NCSUDucker
Does anyone have any ideas on a PVC pipe blind for a small jon boat..14' long..ANYONE..PLEASE!!
- Posts: 1
- Joined: Sun Apr 17, 2005 8:26 pm
- Location: Lumberton, Tx
I have never made one out of pvc ,but I have made one out of electrical condut. I was able to make it pretty cheap. If I could figure out how to post pictures I would post some.
- Posts: 533
- Joined: Wed Mar 16, 2005 3:47 pm
- Location: NORMANDY, TN.
I made a frame from PVC for my 12' duck boat. I used 1" PVC pipe for the up-right posts as well as for the top lateral support post. Then I welded two small C-Clamps to 3/4" metal pipes. I use the clamps on the sides of the boats and the 1" PVC up rights slide right over the metal pipes. When I'm done, just pull the blind off and unclamp it and go. Was cheap and works great.
If the dog retrieves the decoy, go buy another dozen.
- Posts: 9
- Joined: Tue Mar 22, 2005 6:11 am
- Location: Grass Valley, California
3/4 emt (electricall conduit) fits snuggly into schedule 40 grey electrical pvc conduit. This is what I used to build the blind. You need an emt conduit bender which any rental yard will have and will, most if the time, let you use for free in thier yard.
- Posts: 1
- Joined: Wed Apr 20, 2005 6:22 pm
I built a PVC blind frame for a buddies 12' boat. IMO, I think it's a waste of money. The PVC becomes very brittle in below-freezing temps and the glue does not hold the joints together. After a couple of hunts we had to shoot screws in each joint.
I think the EMT conduit will work much better for you with a lot less maintenance and it doesn't really way all that much. My EMT blind frame on my old 14' boat weighed about 20 lbs.
- Posts: 1708
- Joined: Tue Aug 17, 2004 12:22 pm
- Location: Arkansas River Valley
Return to Waterfowl Boats, Motors, & Boat Blinds
Who is online
Users browsing this forum: brownduck, Flogger, ipittythefoo, stevetags and 20 guests