Discussion about Trucks, Cars, Motorcycles, & Trailers.
Moderators: whisperin' duck, fowl_wishes, KCDuckMaster, ajmorell
Looking good and only had to turn it up 1.5" to keep the passenger side from rubbing at all even with quite a bit of suspension compression. the drivers side rubbed a bit on the rear inner fender plastic but the hot knife and a bit of contour work and that is clear too. Plenty of frame clearance all around so that makes me very happy. The alighment was right on for the left and out so little on the right that they told me it was not necessary to mess with it right now. I will have that done when I replace the upper "A" arms to get a bit better ball joint angle. These are Toyo 285/75R18 AT's and measure 35" x 11.5" mounted. if I had went with the 12.5" wide tire I think I would have had a bit of frame rubbing.
My Hunt'n truck is progressing SLOWLY
CPL holder since 1991, NRA Lifetime Member, DU Member, NICET certified
"For those who would give up essential liberty to purchase a little temporary safety, deserve neither Liberty nor safety.—Ben Franklin.”
- Forum & State Moderator
- Posts: 4296
- Joined: Thu Oct 14, 2004 4:53 am
- Location: Saginaw Bay, MI
you going to get some Cognito UCA's? I've got a set on my truck and they ride a lot better! really helps out the lifted and leveled trucks.
I cant wait to get my 38x13.5x18 toyo MT's
NRA and DU member, are you? if not you should be!
rabbitdundied wrote: I use my mojos in places I don't want birds to land.
- Posts: 3369
- Joined: Mon Jul 26, 2010 2:32 pm
- Location: sittin high in the Missouri skies!
Return to Vehicle forum
Who is online
Users browsing this forum: No registered users and 2 guests