Discussion about Trucks, Cars, Motorcycles, & Trailers.
Moderators: fowl_wishes, whisperin' duck, KCDuckMaster, ajmorell
I need off roading plates for my F250. I know you can get aftermarket plates for Jeeps (diffs; tranny; gas tank). Can't seem to find them for trucks.
Any advice? (At least one
serious before the diesel or Chevy boys see this).
I'm the guy your Mother Goose warned you about.
- Posts: 674
- Joined: Fri Sep 24, 2004 10:18 am
- Location: Mercer/Lawrence Co's. W. Pa
I'd just get some 3/16ths- 1/4in plate steel and drill a few holes where you can bolt the plates to the frame. you'd only have to make a few simple bends and welds. I'm about to make a simple one for my front diff and one to replace the factory plastic "splash guard"
NRA and DU member, are you? if not you should be!
rabbitdundied wrote: I use my mojos in places I don't want birds to land.
- Forum Moderator
- Posts: 3211
- Joined: Mon Jul 26, 2010 2:32 pm
- Location: sittin high in the Missouri skies!
Return to Vehicle forum
Who is online
Users browsing this forum: No registered users and 3 guests