Interact with others on shot gun shells, reloading, ballistics, chokes, or anything that has to do with your shooting.
Moderators: donell67, NV Guide, pennsyltucky, Ohio Wildfowler
If I was to have a gunsmith lengthen the forcing cone on my gun, what should I have him lengthen it to? And what is the length now?
- Posts: 163
- Joined: Tue Oct 11, 2005 8:01 pm
u dont get a choice. its either lengthened or its not. they are usually between 1 1/2 and 2" when ur done with em, depending on how tight the bore diameter is. (smaller bore makes a longer cone) its a solid tapered reamer that u use to do it, and u cant change the pitch of the tool.
there are some super long reamers out there that ream to about 5" long, but its a waste of money, even the guys that do it will tell u it is. they just do it cuz the customer WANTS it.
now? depends on the gun... some from 3/8" up to an inch (it would be an advertising point if it were an inch). it depends on gauge, and if its a cheaper gun, it will be short, because thats saami spec so that all they hafta do. when u look at the cone in ur gun, if it just looks like a black ring ahead of the chamber, its short. when lengthened, u will see it as a long gray section thats just a bit darker than the bore, but still shiney.
make sure that it will be honed and polished. matter of fact, u outta have him do the whole length while he's there...... it shouldnt be much extra.
muleskinner wrote:you were born with a silver spoon in your mouth and a benalli in the other.
- Forum Moderator
- Posts: 3167
- Joined: Mon Feb 27, 2006 2:21 pm
- Location: stoneboro, PA
:withstupid: Yup well said...It does make shooting non-tox shells much easier to get uniform patterns out of.
- Membership permanently suspended
- Posts: 2119
- Joined: Wed Sep 28, 2005 1:50 pm
Return to Shotshell, Reloading, Ballistics, & Chokes
Who is online
Users browsing this forum: No registered users and 12 guests