A shotgun forum for basic gun smithing, repair, modifications, and all other detailed shotgun information.
Hi, i bought a used p beretta s686 about a year ago. Just about a month ago the stock started wiggling and now it's completely fallen off. The screw that's internally in the stock became loose and wiggled off so now i need to take off the recoil pad to screw the stock back on. One problem though, the recoil pad won't come off. It's a pachmayr recoil pad and I found the two screw holes and got those out but the recoil pad still wont come off. I've tried about everyting but it's stuck tight. Is there a trick to getting them off or something?
- Posts: 10
- Joined: Sat Jul 07, 2012 5:28 pm
Put it in the freezer, leave it an hr or so, the 2 different properties will cause them to seperate, if not, a simple rap on the counter should break it loose
NRA Life Member
GOA Life Member
NSCA Life Member 646442
- Posts: 2007
- Joined: Sun Feb 27, 2005 10:39 am
- Location: Ft. Worth, Texas
I have found a few that people had used RTV and glued them on in an attempt to keep out moisture when they dip the stock in the water. you might have to go as far as using a very thin knife like a carpet knife and cut between the stock and pad or pry it off. You can even use a pair of large channel locks and grip it at the plastic base and pull it off but tape the stock first to prevent any damage to it.
CPL holder since 1991, NRA Lifetime Member, DU Member, NICET certified
"For those who would give up essential liberty to purchase a little temporary safety, deserve neither Liberty nor safety.—Ben Franklin.”
- Forum & State Moderator
- Posts: 4339
- Joined: Thu Oct 14, 2004 4:53 am
- Location: Saginaw Bay, MI
Return to Shotgun Repair & Modifications Forum
Who is online
Users browsing this forum: No registered users and 2 guests