A shotgun forum for basic gun smithing, repair, modifications, and all other detailed shotgun information.
Moderators: waterfowlhunter, don taylor
I need help!!! I'm leaving in 3 days for a snow goose trip. I just installed a choate magazine extension to my mossberg 935. It is the 9+1. It seems as if the spring is binding when I fully load my gun. I've also had some issues with the shell ejecting from the magazine. It seems as if there is too much tension on the sprIng. I'm thinking about cutting the spring down. Any suggestions?
- Posts: 88
- Joined: Fri Dec 04, 2009 10:51 am
- Location: Millstadt, IL
Was this the spring that came with the mag extension ? Call the mfg before you cut anything.
- Posts: 972
- Joined: Tue Mar 22, 2011 7:23 pm
- Location: Green Bay Wisconsin
you did use the spring and the long orange follower that came withthe extension, Right? with all magazine extensions, Especially longer ones I like to install them and then leave the magazine fully loaded for a couple of weeks to set the spring. Choate recommends that if you are going to store the gun with the magazine loaded you get 2 springs and periodically switch them out so that they do not get too weak.
I would not cut the spring. it will weaken a bit with use.
"A free people ought to be armed" George Washington 1790
‘For those who would give up essential liberty to purchase a little temporary safety, deserve neither Liberty nor safety.’ —Ben Franklin.”
- Forum & State Moderator
- Posts: 3745
- Joined: Thu Oct 14, 2004 4:53 am
- Location: Linden, MI
Return to Shotgun Repair & Modifications Forum
Who is online
Users browsing this forum: No registered users and 3 guests