A duck boat forum to discuss duck hunting boats, mud motors, and everything related.
Moderators: jamesmc, Dogman, NCSUDucker, nitrousneil
I tore my decks off, and gutted my wiring in my boat and have been fixing little things here and there, and painting the bilge area. Finally today I am seeing a little bit of forward progress. I ran out of ring connectors, but I got the rear/main distribution panel is DONE. I have 1 more smaller one to make under the console, and a switch panel to make, and then the wiring can be re-run and get the boat floated again!
Botiz630 wrote:How much does an apostrophe cost down south? Must be quite a bit, based on how sparingly you use them.
- Super Moderator
- Posts: 6087
- Joined: Thu May 06, 2010 7:42 pm
- Location: Everywhere the English language is being abused...
Can't go wrong with heat shrink connectors, nice looking work too!
- Posts: 220
- Joined: Wed Dec 28, 2011 1:24 pm
- Location: Mechanicsville,VA
- Posts: 835
- Joined: Thu Oct 25, 2012 10:52 pm
- Location: Mexizona
Return to Waterfowl Boats, Motors, & Boat Blinds
Who is online
Users browsing this forum: No registered users and 12 guests