Moderator: Quack Wacker NC
z51 wrote:Before you shoot all those shells, detail strip that gun and get all the original grease out of it. Really scrub it. Coat all of the moving parts very lightly with CLP like Break Free. Now cycle the action by hand about 100 times. Go out and shoot those 1290 fps game loads. If they cycle you are good to go.
Batemaster wrote:I am picking it up tomorrow and already had plans to field strip, clean, and lube with Breakfree CLP. Does a little CLP go a long way on these? Mainly on the rails?
Batemaster wrote:Are the bolt and the rails on the gun the MAIN parts that will cause cycling issues?
mudpack wrote:Batemaster wrote:Are the bolt and the rails on the gun the MAIN parts that will cause cycling issues?
If the 930 is like my Beretta, Browning, Winchester, and Remington autoloaders, those parts will give you the least problems.
Main areas to keep clean and lubed are the springs (recoil and magazine) and the gas piston and mag tube that the piston rides on. A little oil goes a long way. A thin film of RemOil does a great job, no matter what some over-lubers say.
Bolt and rails can run just fine dry.
Users browsing this forum: Google [Bot], Google Adsense [Bot], kasey200 and 24 guests