A duck boat forum to discuss duck hunting boats, mud motors, and everything related.
Moderators: jamesmc, Dogman, NCSUDucker, nitrousneil
I'm putting a floor in my aluminum boat . It's aluminum diamond plate and I am looking for thr best primer to use. Parker's is not self etching. Any ideas?
- Posts: 9
- Joined: Fri Jul 26, 2013 5:50 am
Start by using a red scotchbrite pad to rough up the surface, and follow it with some sort of etching wash. I prefer NAPA Alumabrite, but i have seen 50/50 vinegar - water mixes. This will give an etched surface for the paint to stick to. Next prime with a zinc chromate primer. If you can't find it, I have used the rustoleum self etching primer for aluminum found at Home Depot and have been satisfied with my results.
Botiz630 wrote:How much does an apostrophe cost down south? Must be quite a bit, based on how sparingly you use them.
- Super Moderator
- Posts: 5514
- Joined: Thu May 06, 2010 7:42 pm
- Location: Everywhere the English language is being abused...
Proper prep is the most important. scuff!!, clean/degrease, clean/degrease, clean/degrease, then use a zinc chromate primer. I used duplicolor and rustolium selfetching primer and it won't stick good unless it has something to really bite into. I plan to spend the $$ next time and go zinc chromate. Cheapo in me went with the duplicolor/Rust self etching and I'm having pain chip off when hit with a hard blow or hard bump with the dock.
Just my $0.02 from my experience.
- Posts: 278
- Joined: Wed Feb 01, 2012 1:42 pm
- Location: Eastern NC
Return to Waterfowl Boats, Motors, & Boat Blinds
Who is online
Users browsing this forum: brstanle, h.kizzle, jimposten and 29 guests