A duck boat forum to discuss duck hunting boats, mud motors, and everything related.
Moderators: jamesmc, Dogman, NCSUDucker, nitrousneil
Looking to upgrade my boat from a riveted 16' to a welded 16-18'. i currently have a 40hp yammie EFI. Would this motor be sufficient for a welded 18ft boat with 3 guy and gear or should i stick with a 16-17?
- Posts: 57
- Joined: Thu Oct 04, 2012 3:18 pm
- Location: potomac-chesapeake
- Posts: 9
- Joined: Fri Sep 20, 2013 4:53 pm
if the hull is a 1848 the 40 should be satisfactory. the extra length will help to carry a load better than a shorter boat. if you go with a wider boat such as a 1860(which is a common hull in 18ft) then i would put a 60hp on it.
- Posts: 101
- Joined: Fri Jan 23, 2009 10:03 am
a 16ft of any sort should be fine with a 40 a 18ft not so much as stated before a 1848 would be ok but if I were going 1860 I'd want at least a 60 if not a 90.
Red neck engineering- If ya can't fix it with duck tape, bailing wire, zip ties, and JB weld well than it can't be fixed.
If it moves and it aint suppose to duck tape it. If doesn't move and its suppose to put WD-40 on it.
- Posts: 589
- Joined: Wed Feb 08, 2012 12:39 am
- Location: crothersville IN
Return to Waterfowl Boats, Motors, & Boat Blinds
Who is online
Users browsing this forum: jeepman and 12 guests