waterfowlhunter wrote:Do you just need to shorten the stock or do you need to bend it too? if you are just going to shorten it then there is no effect to the duratouch but bending it might effect not only the duratouch but also the ink it was dipped in for the camo pattern. You just tape it up good with some heavy painters tape (will not pull off the duracoat when removed) and cut on the tape to the size you need. I use a 14" compound mitre saw with a very fine carbide tipped blade and have never had any issues.
on the duratouch pealing issue, You can send it in and they will fix it under warranty. I have seen them pealing before they even left the gun store and others tend to last for years. My X2 is holding up great so far.
Users browsing this forum: No registered users and 6 guests