Duck Hunting Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
have a question???
new to this thing so i need some advice

I live and hunt on lake tillery NC. have a 15 foot polar kraft with a 15 evinrude on the back. am building a blind on the boat and kneed to know what everyone thinks is the best blind and the best camo for the blind. any help appreciated.
later
 

·
Registered
Joined
·
41 Posts
[/i][/b]Well i dont know what kind of cash you want to spend but you could build the fram out of 1/2 by 1/2 tubbing thin walled and if its a aluminum boat you need to put about 2 lays of duck tape on the tubb first befor u put the fram on the boat and as far as what to put on the fram u could u rubber/ you can get rubber roffing at a lumber yard its light and u can attach it to the fram with wire ties and as far as the camo i like fast grass for me . Hope that help.

Tom.
 

·
Registered
Joined
·
271 Posts
Here is one I built for my 16' PolarKraft.



I used 1" square aluminum tubing with 1/8" thick inner wall. I attached it to the boat using standard bimini top parts that can be ordered/purchased from any boating supply place. I can install it on the boat in five minutes and raise/lower it in 10 seconds. As for the camo, you need to look at where you will be hunting with it. If hunting around grassy marshes & such, the Avery Grass mats work nicely. Four on either side (attached to the blind using zip ties, gear grabbers, etc) and one on the bow. This will make it wrap around the motor nicely. You can also order material (cloth, netting, etc) and mount it on there.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top