Duck Hunting Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
134 Posts
Discussion Starter · #1 ·
Do not know whether this is a common issue with the SP10 as I have had it about a year. Gun works great but just recently,
load the first round in the chamber and then depress (hold)
button to load the magazine and (do not know part name-lost
manual) metal guide will not move and allow me to put the 2 rounds in the magazine. Gun is cleaned and I remove trigger to clean that also, I know if it is not a common problem take it to a gun-smith but just in case it is a Remington thing.!!!

Thanks in advance

John
 

·
Registered
Joined
·
2,640 Posts
That is a simple problem. when you put the trigger assembly into the receiver, you did not line up the latch correctly. There is a latch arm on the front end of the trigger assembly that slips into a groove ont he side button. It is possible to put the trigger assembly in incorrectly withtaht piece misaligned.
 

·
Registered
Joined
·
134 Posts
Discussion Starter · #3 ·
Hey Awesome:

Thanks very much, I will align that later on tonight and be done with it.

It pays to ask questions, I very well could of taken that in to a
gunsmith and cost me some $$$$, not a bad thing but advise such as your is free.

Again Thanks very much

John
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top