Scouring powder is the best thing to use to get all the oils off. Just scrub and wash off with high pressure water. Ned S
repainting a boat
Ok I have a couple of questions about repainting my jon boat. I'm in the process of sanding it down and this is where my first question comes to play. I have been doing the sanding with a handheld sander, I also have a angle grinder. I have tried a little of both and the angle grinder seems to make the aluminum more rough than the handheld. I'm using the same grit sand paper so I know thats not it. Both are 50 grit. Any advice on this?
The second question is paint and primer. Since I am sanding it down first do I need primer? and for paint i was going to use krylon, does anyone else have any different suggestions? Thanks for any help you might be able to give.
The second question is paint and primer. Since I am sanding it down first do I need primer? and for paint i was going to use krylon, does anyone else have any different suggestions? Thanks for any help you might be able to give.
1 - 1 of 11 Posts
1 - 1 of 11 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Duck Hunting Forum
A forum community dedicated to duck hunters and hunting enthusiasts. Come join the discussion about safety, gear, tips, tricks, optics, hunting, gunsmithing, reviews, reports, accessories, classifieds, and more!
Full Forum Listing
